SiRIE Based Flourine Etcher for Bosch MEMs Processes

SiRIE Based Flourine Etcher for Bosch MEMs Processes
SiRIE Based Flourine Etcher for Bosch MEMs Processes
SiRIE Based Flourine Etcher for Bosch MEMs Processes

Equipment Description:
SiRIE Based Flourine Etcher for Bosch MEMS Processes

Manufacturer:
Plasmatherm (Unaxis)
10050 16th Street
North St. Petersburg, FL 33716
Telephone: (727) 577-4999
Fax: (727) 577-7035

 

 

 

 

 

 

General Information and Usage:

The SiRIE system is a Plasma-Therm 770 SLR series system with a loadlock. The system has an Inductively Coupled Plasma (ICP) coil and a capactively coupled substrate RF supply to independently control plasma density and ion energy in the system. This system is dedicated to deep etching in silicon for MEMs structures. The Bosch process is used for obtaining the deep, vertical, high aspect ratio structures. This process cycles between a polymer deposition cycle using C4F8 gas and no substrate bias, and an etching cycle using a SF6 / Ar mixture with substrate bias. The system is fully computer controlled in all aspects of the pumping cycles and process control, and can be programmed by the user. The fixturing is configured for 4" diameter Si wafers and uses a clamp to hold the sample on the RF chuck.

The materials allowed in the system are limited to Silicon, SiO2, Si3N4, SiOXNY, and polymer films such as photoresist, PMMA, and polyimide. Other materials can be placed in the chamber, such as metal layers on the surface, only if they will remain completely protected from the plasma by an allowed material during the entire etch. Some alternate stop-etch materials may be allowed upon discussion with facility staff.

He back-side cooling is used to keep the sample cool during the etch. This is very important as the polymer passivation layer is chemically etched away by the fluorine gas at elevated temperatures, resulting in loss of profile control. Pieces of wafers can be mounted onto 4" silicon wafers using thin, uniform, bubble-free hard baked photoresist. The etch rate is dependent on the open area of silicon (macro-loading effect) with large open area samples etching slower than small open area samples. Features with a high aspect ratio will also etch slower than more open areas. This is known as RIE lag or the micro-loading effect.

 

Detailed Specifications:

  • 1000 W ICP coil power at 2 MHz and 500 W substrate bias at 13.56 MHz plasma generators
  • C4F8, SF6, O2, Ar, N2 gases available
  • He-back-side cooling
  • Windows-based computer control of process and wafer handling
  • Allowed materials: Silicon, SiO2, Si3N4, SiOXNY, and polymer films such as photoresist, PMMA, and polyimide; other stop-etch materials on request
  • Realized etch rates (including passivation steps) of > 3 um / min. Using the standard Plasma Therm recipe, a nominal etch rate of 2 um / min. is achieved; etch rate dependent on conditions and open area

 

Contact Information:

For additional information regarding the SiRIE Based Flourine Etcher for Bosch MEMS Processes or if you would like to inquire about using the UCSB Nanofabrication Facility, please contact This email address is being protected from spambots. You need JavaScript enabled to view it.  using the telephone number or e-mail address below. 


This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: (805) 893-3918 ext. 216

E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Technical and educational staff services are possible through the generosity of the National Science Foundation through support via the NNIN.